Leckey Mygo Max User Manual page 12

Always check the handle and
locking pin are fully engaged
before you place the child in
the seating system. If the handle is
not engaged properly the seat unit
can come loose and could cause
serious injury to the child or carer.
Once the front of the seat is lowered
fully, release the handle and push it
forward to ensure it has fully engaged on
the front tube. Rotate the safety locking
pin so it engages in front of the handle.
If it hits the handle then the seat is not
inserted properly. Remove and repeat
process outlined above.
9.3 ATTACHING THE
PUSH HANDLE
The push handle is attached to the
seatbase by inserting the two lower
stems into the receiving tubes as shown.
Secure the handle in place by tightening
the locking knobs
Check these regularly to make
sure the knobs are tight,
particularly if you are moving
the product unit along corridors that
may have uneven or sloping surfaces.
Mygo Max User Manual p12
A
.