Page 1
Replace For flux-cored welding, consumables keep contact tip closer (ideally under 1/4"). FIND MORE INFORMATION AT FORNEYIND.COM QUESTIONS OR TROUBLE? Contact Forney Industries at 1-800-521-6038 customerservice@forneyind.com forneyind.com...
Page 2
ITEM# 323 MIG QUICK START GUIDE 190 MP WELDER TruSet ™ 1. Select process according to diameter of wire being used (TruSet MIG .024”, .030”, or .035”). 2. Follow steps 3-9 of Manual MIG setup. 3. Push the right knob to light up the Wire/Gas LED then turn the knob to select the wire and shielding gas combination being used.
Page 3
• Generators must be a minimum 4,000W continuous output with no low-idle function • Generators must be a minimum 10,500W continuous output with no low-idle (or low-idle off), 5% THD Max. function (or low-idle off), 5% THD Max. QUESTIONS OR TROUBLE? Contact Forney Industries at 1-800-521-6038 customerservice@forneyind.com forneyind.com...
Page 4
• Generators must be a minimum 4,000W continuous output with no low-idle function • Generators must be a minimum 10,500W continuous output with no low-idle function (or low-idle off), 5% THD Max. (or low-idle off), 5% THD Max. QUESTIONS OR TROUBLE? Contact Forney Industries at 1-800-521-6038 customerservice@forneyind.com forneyind.com...