TEFAL OPTIGRILL GC705 Instructions For Use Manual page 26

EN
19
4
Comments
21
50
19 -20 When the colour of the cooking
level indicator (A6) corresponds to the
degree of cooking you require, open
the appliance and remove the food.
20
21 Close the appliance. The control panel
will light up and set itself to 'choice of
program' mode.
Comment: the security system will
turn off automatically if no program
selection is made.
How to cook another batch of food:
After finishing your first batch of food:
1. Make sure the appliance is closed
with no food inside.
2. Select the appropriate cooking
mode/program (this step is necessary
even if you decide to pick the same
cooking mode than for the previous
batch of food).
3. Press the "OK" button: the
appliance starts pre-heating. The pre-
heating is symbolized by the cooking
level indicator that flashes purple.
4. The pre-heating is complete when an
audible beep is heard and the cooking
level indicator stops flashing purple.
5. After the pre-heating, the appliance
is ready for use. Open the grill and
place the food inside the appliance.
Important:
- Please note that any new batch
of food, the pre-heating phase is
mandatory. Remember to always
have the grill closed and no food
inside in order for the pre-heating to
effectively function.
22
23
24 25
- Then wait for the pre-heating to be
complete before opening the grill and
place the food inside.
N.B.: if the new pre-heating cycle is
carried out immediately after the
end of the preceding cycle, the pre-
heating time will be reduced.
EN
22-23-24
Cook the food according to your
personal taste (except for cooking
food under 4 mm thick where the
cooking cycle has been started by
pressing 'OK')
If you want to cook food to different
personal tastes, once you have placed
it on the grill, open the lid and remove
the food when it has reached the
desired level and then close the grill
and continue cooking the other food.
The program will continue its cooking
cycle until it reaches the 'well done'
level.
25 Keeping warm function
When the cooking process has
finished, the appliance will start the
keep warm function; the indicator will
switch to flashing red and will emit a
beep signal every 20 seconds. If the
food is left on the grill, it will continue
cooking while the cooking plates cool
down and during the keeping warm
function. You can turn of the beep
signal by pressing the 'OK' button.
Comment: the safety system will turn
the appliance off automatically after
a certain amount of time.
51