Table of Contents
Advertisement
Cleaning and Maintenance
Dust Cup Cleaning
If the suction power is still low after the above steps, wash the dust cup
with water.
Clean the separate mesh: Remove the garbage on the mesh part and the edge of
the cup with a cleaning brush, and wipe it with a damp cloth.
Wash with water: Wash the parts with water, dry the dust cup filter until no water
splashes, and then place it in a cool place to dry.
Cleaning brush
Mesh part
Separating filter
1. Do not use detergent or other agents for cleaning;
2. After washing, it must be completely dried before putting it back into use;
3. Do not use hair dryer for drying;
4. The dust cup cotton filter is consumable. To replace it, please contact the TOSHIBA After Sales.
Mesh part
Cleaning and Maintenance
Electric floor brush cleaning
When the roller brush or wheels are entangled with garbage or dirty,
please clean them.
Remove the floor brush
a. Use a coin or other tools to move the floor brush buckle in the direction of the arrow;
b. Remove the protective cover;
C. Pull up the belt;
D. Lift the roller brush.
Groove
Buckle
Roller brush
Clear garbage
a. Remove the garbage wrapped around the roller with tweezers, and wipe the inside with a dry
cloth;
b. Cut off the garbage entangled on the roller brush with scissors, and remove the garbage in
the gap between the two ends;
c. Remove the garbage on the gear with a brush. The rotating part and the protective cover can
be washed with water. After washing, please fully dry it in a dry place.
Roller
Gap
Roller
Be careful not to cut
Roller
the bristles
Protective cover
Belt
Gap
Gear
Advertisement
Table of Contents
