Sanyo LC-XBL20 Owner's Manual page 51

Setting
Power management
For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off the
projection lamp when the projector is not operated for a
certain period.
Select one of the following options:
Ready . .............. When the lamp has been fully cooled
Shut down ....... When the lamp has been fully cooled
Off .................... Power management function is off.
Timer . ............... If the input signal is interrupted and
Note:
Factory default is Ready: 5 min.
On start
When this function is set to On, the projector will be
automatically turned on just by connecting the AC power
cord to a wall outlet.
Note:
• When Standby mode is set to Eco, On start cannot be
selected. If you want to set On start to On, Standby
mode must be set to Network.
• Be sure to turn off the projector properly (see "Turning Off
the Projector" on page 20). If the projector is turned off in
the incorrect sequence, the On start function will not
work properly.
50
down, the POWER indicator changes
to green blinking. In this condition,
the projection lamp will be turned on if
the input signal is reconnected or any
button on the top control or remote
control is pressed.
down, the power will be turned off.
no button is pressed for more than
30 seconds, the timer display with
No signal appears. It starts the
countdown until the lamp is turned off.
Use the Point buttons to set the
▲▼
Timer(1~30min).
Power management
Time left before Lamp is off.