Receiver-Based Programming - Remote Control FAAC TX2 SLH Programming Manual

Receiver-based programming:

1. Open the casing of your receiver. Open the casing of your receiver. It is located next to your motor.
2. Press both buttons P1 and P2 on y Press both buttons P1 and P2 on your new remote control (figure 2). Keep them pressed
down. The LED light on your new remote control blinks. Let the buttons go. down. The LED light on your new remote control blinks. Let the buttons go. down. The LED light on your new remote control blinks. Let the buttons go.
3. On the receiver circuit board, press the programming button (SW1). On the receiver circuit board, press the programming button (SW1). The LED light on the
receiver blinks. Let the button go. receiver blinks. Let the button go.
4. While the LED light on your new remote control blinks, press a button on your new remote the LED light on your new remote control blinks, press a button on your new remote the LED light on your new remote control blinks, press a button on your new remote
control. Keep it pressed down. The LED light on the receiver stays lit constantly and then control. Keep it pressed down. The LED light on the receiver stays lit constantly and then control. Keep it pressed down. The LED light on the receiver stays lit constantly and then
goes out.
5. Let the buttons go.
6. Wait 10 seconds.
7. Your new remote control is progra Your new remote control is programmed.
http://www.remotecontrol-express.com
Programming Manual
our new remote control (figure 2). Keep them pressed
express.com - TEL : +44 (0) 207 399 7782 - FAX : +44 (0) 207 927
The LED light on the
+44 (0) 207 927 3151