Remote Control FAAC TX2 SLH Programming Manual

FAAC TX2 SLH
Remarks:
- In this line of remote controls, there are "master"
controls.
- Only "master" remote controls can transmit their programming codes to other remote Only "master" remote controls can transmit their programming codes to other remote Only "master" remote controls can transmit their programming codes to other remote
controls.
- To recognize them, press a button and keep it pressed down: To recognize them, press a button
- If the LED light blinks once and then remains lit constantly, it is a "master" remote If the LED light blinks once and then remains lit
control
- If the LED light remains lit constantly, it is a "slave" remote control If the LED light remains lit
- Remote Control Express only se
- The coding process will incite the opening of your garage door. To avoid an accident, we The coding process will incite the opening of your garage door. To avoid an accident, we The coding process will incite the opening of your garage door. To avoid an accident, we
recommend that you program your remote control while inside your garage. recommend that you program your remote control while inside your garage. recommend that you program your remote control while inside your garage.
Programming of your new remote control ming of your new remote control:
There are several methods for programming your new remote control.

Remote-to-remote programming

remote programming:
ATTENTION : During the coding process, if you press one of the buttons o During the coding process, if you press one of the buttons on the new remote control
first, you run the risk of erasing the codes of all of the remote controls that have already been first, you run the risk of erasing the codes of all of the remote controls that have al first, you run the risk of erasing the codes of all of the remote controls that have al
programmed
1. Place an already-programmed remote control next to the new remote control so they touch
as shown in fig 1.
2. Press the buttons P1 and P2 from your already Press the buttons P1 and P2 from your already-programmed remote control
time (fig 2). Keep them pressed do (fig 2). Keep them pressed down. The LED light on your old remote control blinks. Let
the buttons go.
3. Press a button on your old
4. While keeping the button While keeping the button on your old remote pressed down, press the same button
new remote control. Keep them pressed down. new remote control. Keep them pressed down.
5. The LED light on your new remote control blinks twice.
6. Let the buttons go.
7. Wait 10 seconds.
8. Your new remote control is programmed. Your new remote control is programmed.
http://www.remotecontrol-express.com
Programming Manual
TX2 SLH - TX4 SLH - TML4 SLH
te controls, there are "master" remote controls and "slave" remote
Express only sells "master" remote controls
for programming your new remote control.
programmed remote control next to the new remote control so they touch programmed remote control next to the new remote control so they touch
old remote control.
your new remote control blinks twice.
express.com - TEL : +44 (0) 207 399 7782 - FAX : +44 (0) 207 927
remote controls and "slave" remote
, it is a "master" remote
the new remote control
programmed remote control at the same
remote control blinks. Let
pressed down, press the same button on your
+44 (0) 207 927 3151