Remote Control GENIUS JA 332 Programming Manual

Programming of your new remote control:
There are several methods for programming your new remote control.

Remote-to-remote programming:

ATTENTION : During the coding process, if you press one of the buttons of the new remote control
first, you run the risk of erasing the codes of all of the remote controls that have already been
programmed
1. Place an already-programmed remote control T1 next to your new remote control T2 so they
touch as shown in the diagram above (fig B).
2. Press the buttons P1 and P2 on your already-programmed remote control at the same time.
(fig A). Keep them pressed down. The LED light on your already-programmed remote control
blinks. Let the buttons go.
3. While the LED light on your already-programmed remote is blinking, press a button on your
already-programmed remote control. Keep it pressed down. (fig C). The LED light on your
new remote control illuminates.
4. While keeping the button on your already-programmed remote control pressed down, press
the same button on your new remote control (fig D). Keep it pressed down. The LED light on
your new remote control blinks twice. Let the buttons go.
5. Wait 10 seconds.
6. Your new remote control is programmed.
http://www.remotecontrol-express.com
Programming Manual
GENIUS JA 332 - JA334
- TEL : +44 (0) 207 399 7782 - FAX : +44 (0) 207 927 3151