Download Print this page

Remote Control NICE Moon MOTX-R Programming Manual

Programming of your new keyboard with a FLOX-R receiver

1. Open the casing of your receiver. It is located next to your motor.

2. On the receiver circuit board, press the programming button (P1). Keep it pressed down. The

LED light on the receiver illuminates. Let the button go.

3. Type « 11 » on the keyboard. Press the button «

on the receiver turns off. Let the button go.

4. Press the button «

times.

5. Wait 10 seconds.

6. Your keyboard is programmed.

http://www.remotecontrol-express.com

Programming Manual

NICE Moon MOTX-R

» again for 2 seconds. The LED light on the receiver blinks three

- TEL : +44 (0) 207 399 7782 - FAX : +44 (0) 207 927 3151

». Keep it pressed down. The LED light

Table of Contents

Do you have a question about the NICE Moon MOTX-R and is the answer not in the manual?

Page 1 Programming Manual NICE Moon MOTX-R Programming of your new keyboard with a FLOX-R receiver 1. Open the casing of your receiver. It is located next to your motor. 2. On the receiver circuit board, press the programming button (P1). Keep it pressed down. The LED light on the receiver illuminates.
Page 2 Programming Manual Programming of your keyboard with an SMXI receiver in MODE I (general) 1. Open the casing of your receiver. It is located next to your motor. 2. On the receiver circuit board, press the programming button. Keep it pressed down. The LED light on the receiver illuminates.