Advertisement
PD9330
Input: 105-130 VAC 60 Hz
500 Watts
Output: 13.6 VDC – 14.7 VDC,
30 Amps
Dimensions: 4.5H x 8.25L x 7.25W
Weight: 4.5lbs
PROBLEM
1. No Output
2. External Fuses Blown
3. Low Output
4. Intermittent or no Output on
Generator, works on Shore
Power
5. High Output
See website
LIMITED WARRANTY: Progressive Dynamics, Inc. warrants its power control center to be
free from defects in material or workmanship under normal use and service for a period of two
years from the original date of purchase; and limits the remedies to repair or replacement.
This warranty is valid only within the continental limits of the United States and Canada.
See website
PD9345
Input: 105-130 VAC 60 Hz
725 Watts
Output: 13.6 VDC – 14.7 VDC,
45 Amps
Dimensions: 4.5H x 8.25L x 7.25W
Weight: 4.5lbs
TROUBLE SHOOTING GUIDE
POSSIBLE CAUSES
Proper AC power not connected
External Fuses Blown
Short Circuit
Unit has shutdown due to overheating
Unit has shutdown due to over voltage
(Also see Item 4 below)
Reverse Battery Hook Up
Excessive load for converter
Input voltage not between 105-130 VAC
Bad battery cell(s)
Mild Overheating
Incorrect Output Mode
Unit has shutdown due to over voltage.
Some generators exhibit excessive voltage
spikes on the AC power output, this may cause
the over voltage protection to shut the unit
down
Incorrect Output Mode
Please refer to website for further trouble shooting information.
www.progressivedyn.com
www.progressivedyn.com
PD9360
Input: 105-130 VAC 60 Hz
1000 Watts
Output: 13.6 VDC – 14.7 VDC,
60 Amps
Dimensions: 3.6H x 8L x 9W
Weight: 5.8lbs
Connect power supply
Check AC distribution panel for proper operation
Check for reverse polarity
Replace fuses with same type and rating
Trace circuits for possible fault
Check air flow
Allow unit to cool
Check input voltage
Converter will shut down if the input voltage exceeds 132 Volts
Correct input voltage
Correct hook up and replace fuses with same type and rating
Reduce load requirements or install larger converter
Correct input supply voltage
Replace battery
Check air flow
Allow unit to cool
Change output mode
Add another load to the generator, this may reduce the "spikes" to
an acceptable level
Contact generator manufacturer for possible defect in the
generator
Change output mode
for more troubleshooting information and return instructions.
for more warranty information and return instructions
PD9380
Input: 105-130 VAC 60 Hz
1300 Watts
Output: 13.6 VDC – 14.7 VDC,
80 Amps
Dimensions: 3.6H x 8L x 9W
Weight: 6.0lbs
ACTION
Advertisement
