Advertisement
FEATURES
MULTIPLE BATTERY CHARGING... INTELI-POWER
converters have the capability of charging multiple batteries at
the same time! They can even charge a combination of
different capacity batteries.
GFCI PROTECTION... INTELI-POWER converters have
the LOWEST ground fault leakage. The user can confidently
utilize the RV's AC outlets without concern of ground fault
interruption of the facilities power source.
REVERSE BATTERY PROTECTION prevents damage if
battery leads are cross connected. Since the only consequence
of cross connection is a blown fuse, damage to or possible
replacement of the converter is avoided. Cross connection of
battery leads is the only thing that will blow these fuses.
Replacement fuses are available at any automotive store.
GENERAL OPERATION
The INTELI-POWER series converter will supply "clean"
power from input voltages that range from 105-130 VAC.
LEAD ACID W/O WIZARD (MAGENTA LIGHT) - The
full rated load is available for load, battery charging or both.
When charging the battery, the converter has a nominal
voltage output of 13.6 VDC.
⚠ CAUTION
DO NOT STORE VEHICLE FOR EXTENDED
PERIODS OF TIME IN THIS MODE.
LITHIUM W/ 2 STAGE CHARGE (BLUE LIGHT) –
When charging the battery, the converter has a nominal
voltage output of 14.6 VDC. When the converter senses an
output current drop below a preset level, the converter will
automatically switch to IDLE mode and the voltage output
will drop to 13.6VDC
⚠ CAUTION
DO NOT USE TO RECHARGE FLOODED
LEAD/ACID BATTERIES WHILE IN EITHER
LITHIUM (BLUE) OR AGM (WHITE) MODE
Accessory Port
Press and hold the MODE BUTTON for at least 3 seconds until the LED changed color.
Side of Converter
Continue to depress button until the desire battery type is selected.
See
www.progressivedyn.com
IF THE REVERSE BATTERY PROTECTION
FUSES ARE BLOWN DURING INSTALLATION,
CHECK TO SEE THAT THE BATTERY HAS BEEN
CONNECTED PROPERLY BEFORE REPLACING
THE FUSES. REPLACE THE FUSES ONLY WITH
THE SAME TYPE AND RATING AS THE
ORIGINAL FUSES. USING OTHER FUSES MAY
RESULT IN CONVERTER DAMAGE, VEHICLE
DAMAGE, INJURY OR OTHER CONSEQUENCES
IT IS IMPORTANT THAT THE FLUID LEVEL OF
ANY CONNECTED BATTERIES BE CHECKED ON
A REGULAR BASIS. ALL BATTERIES WILL
"GAS" AND LOSE SOME FLUIDS WHEN
CONTINUOUSLY CONNECTED TO ANY
FLOODED LEAD ACID (GREEN LIGHT) - When
charging the battery, the converter will sense voltage on the
battery and automatically select the proper operating mode to
provide the correct charge level to the batteries. If the voltage
drops below a preset level the converter will automatically
switch to BOOST mode and the output voltage will increase
to approximately 14.4 VDC to rapidly recharge the battery.
When the converter senses an output current drop below a
preset level, the converter will automatically switch to
NORMAL mode and the voltage output will drop to
13.6VDC. If there is no significant battery usage for 33 hours
the converter will automatically switch to STORAGE mode
and the output voltage will drop to 13.2 VDC. In storage
mode, the output voltage increases to 14.4 VDC for
approximately 15 minutes every 21 hours to help prevent
sulfation of the battery plates.
AGM (WHITE LIGHT) – When charging the battery, the
converter has a nominal voltage output of 14.0 VDC. After a
preset time, the converter will automatically switch to
ABSORPTION mode and the voltage output will increase to
14.7VDC. When the converter senses an output current drop
below a preset level, the converter will automatically switch to
FLOAT mode and the voltage output will drop to 13.6VDC
Mode Button Access
for more detailed description of operation
⚠ CAUTION
(SEE WARRANTY).
⚠ CAUTION
CHARGING SOURCE.
Mode Indicator LED
Green – Lead Acid w/ Wizard
Blue – Lithium
White – AGM
Magenta – Constant Voltage
Advertisement
