Advertisement
Quick Links
Safety Notice
The manufacturer is discharged from liability when damage
is caused by improper use or installation.
If any luminaire and/or accessory is subsequently modi-
fied, the persons responsible for the modification shall be
considered as manufacturer.
Product Information / Surge Protection
As an option, this luminaire can also be fitted with a surge
protector of Type 2-3 (at the time of order). The technical
data can be found directly on the installed device. If the
surge protector has been triggered by an adverse event,
the luminaire is automatically disconnected from the
mains. In that case, the LED on the surge protector no
longer lights up.
For comprehensive protection of the luminaire against
lightning and electrical surges, primary (Type 1) and
secondary (Type 2) surge arrestors must be installed into
the power supply. We recommend a combination arrestor
(Type 1+2+3), which is installed in the control cabinet.
WE-EF LIGHTING USA
Tel +1 724 742 0030
info.usa@we-ef.com
we-ef.com
The technical planner/installer is responsible for the pro-
per selection, sizing and installation of the surge protection
modules that must be provided on site. Please note the
various protection levels for Class I and II, as well as the
applicable statutory provisions regarding surge protection.
Installation and maintenance may only be performed by a
qualified electrician.
OLV300 LED_130122 / 006-1201
Technical specifications are subject to change.
© WE-EF 2022
WE-EF LIGHTING
Installation and
Maintenance Instructions for
Wall luminaires
surface mounted
OLV300 LED Series
Advertisement
Related Manuals for WE-EF OLV300 LED Series
Summary of Contents for WE-EF OLV300 LED Series
- Page 1 Installation and maintenance may only be performed by a surface mounted longer lights up. qualified electrician. OLV300 LED Series For comprehensive protection of the luminaire against lightning and electrical surges, primary (Type 1) and secondary (Type 2) surge arrestors must be installed into the power supply.
- Page 2 C and D. * Nominal power, for latest data refer to legislation. www.we-ef.com Installation Procedure Ø 0.197 – 0.512 in max. 16 AWG 1) Switch off the mains electrical supply.
- Page 3 2) Mount the frame H and firmly tighten the Fixing Dimensions Fixing Dimensions mounting screws E. OLV330/334 OLV340/344 3) Loosen the set screws A and take off the moun- ting bracket B from the luminaire. Insert the connection cable through the conduit C of the holding device B and fasten the holding device ø...
- Page 4 4) Loosen the screw J to release the LED heat sink 7) Fold in LED heat sink K and fasten using the Luminaire Replacement K and swing out. screw J. The LED module can be replaced by qualified per- sonnel with appropriate professional qualifications 5) Insert connection cable through the luminaire, 8) Mount the frame H and firmly tighten the and with standard tools.