One Stop Systems OSS-PCIe-HIB25-X8 Installation Manual

Pcie x8 gen2 cable adapter

Advertisement

Quick Links

PCIe x8 Gen2 Cable Adapter
Model: OSS-PCIe-HIB25-x8
Installation Guide
SKU: OSS-PCIe-HIB25-X8
www.onestopsystems.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OSS-PCIe-HIB25-X8 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for One Stop Systems OSS-PCIe-HIB25-X8

  • Page 1 PCIe x8 Gen2 Cable Adapter Model: OSS-PCIe-HIB25-x8 Installation Guide SKU: OSS-PCIe-HIB25-X8 www.onestopsystems.com...
  • Page 2 One Stop Systems Install PCIe card Plug-in your 3rd party PCIe card in the expansion backplane. Use the downstream slot of the OSS backplane. See photos below. Install link cable  Connect the PCIe iPass x8 cable between the host and target cards. Plug in the cable to the host card.
  • Page 3 One Stop Systems Connect ATX Power Supply If you are using an expansion chassis, the power supply is already part of the unit. You can skip this step. If you are using an expansion backplane, plug-in the ATX power supply cable into the 24pin ATX power connector on the OSS board Connect power to the PSU and turn the switch to ON position.
  • Page 4 One Stop Systems Verify Hardware A operational host and target cards will have the following LEDs on the board illuminated. PWR LED x4 CBL and EDGE LEDs x8 CBL and EDGE LEDs LED Definition PWR – Board has power CBL – Signal detect on cable* EDGE –...
  • Page 5 One Stop Systems LED Configuration Explanation Indication No valid signal from root or endpoint Root is sending valid training signals on either lane 0 only (x1) or lanes 0-3 (x4) to the target; no valid signal coming from endpoint. Root is x8 and is sending valid training signals on lanes 0-7 to the root; no valid signal coming from endpoint.
  • Page 6 One Stop Systems Software Installation No software or driver is required for the Host Adapter card. OSS-PCIe-HIB25x8| 21...
  • Page 7 If factory service is required, a Service Representative will give you a Return Merchandise Authorization (RMA) number. Put this number and your return address on the shipping label when you return the item(s) for service. Please note that One Stop Systems WILL NOT accept COD packages, so be sure to return the product freight and duties-paid.
  • Page 8 One Stop Systems OSS-PCIe-HIB25x8| 23...

Table of Contents