Safety Instructions; Technical Data - BorMann BWR5120 User Manual

EN
Read carefully and understand all ASSEMBLY AND OPERATION INSTRUCTIONS before operating.
Failure to follow the safety rules and other basic safety precautions may result in serious personal injury.
WARNING!

Safety instructions

1. Study, understand, and follow all Instructions before operating this device.
2. Do not exceed rated capacity.
3. Use only on hard, level surfaces, with less than 3 degrees of slope.
4. Adequately support the vehicle before starting repairs.
5. Use of this product is limited to the removal, installation, and transportation in the lowered position, of transmissions, transfer cases, and transaxles.
6. No alterations shall be made to this product.
7. Only attachments and/or adapters supplied by the manufacturer shall be used.
8. Do not get under or allow anyone under the vehicle until it has been supported by jack stands.
9. Center load on saddle prior to lifting.
10. Never use on a lawn mower or lawn tractor.
11. Do not use this jack for any use other than the manufacturer specified usage.
12. Failure to heed these markings may result in personal injury and/or property damage.

Technical data

Capacity:
Min. Lifting range:
Max. Lifting range:
Base L x W:
Inspection
• Inspect the jack carefully before each use. Ensure the jack is not damaged, excessively worn, or missing parts.
• Do not use the jack unless it is property lubricated.
• Using a jack that is not in good clean working condition or properly lubricated may cause serious injury.
• Inspect the work area before each use. Make sure it is free and clear of any potential hazards.
WARNING! DO NOT OPERATE OR REPAIR THIS EQUIPMENT WITHOUT READING THIS MANUAL.
To maintain the transmission jack and user safety, the owner is responsible for reading and following these instructions.
• Inspect the service jack for proper operation and function.
• Keep instructions readily available for equipment operators. Make certain ail equipment operators are properly trained; understand how to safely and cor-
rectly operate the unit.
• Allow unit operation only with all parts in place and operating properly.
• Use only genuine replacement parts. Service and maintain the unit only with authorized or approved replacement parts negligence will make tile jack unsafe
for use and void the warranty.
• Carefully inspect the unit on a regular basis and perform all maintenance as required.
• Store these instructions in the handle of your jack. Keep all decals on the unit clean and visible.
• Safety: always follow safely precautions when installing and operating this jack.
• Before proceeding ensure that you fully understand and comprehend the full contents of this manual.
• Failure to operate this equipment as directed may cause injury or death.
• The distributor is not responsible for any damages or injury caused by improper use or neglect.
WARNING! ALWAYS USE JACK STANDS!
DO NOT USE wood blocks or any other non-approved load sustaining devices. The manufacturer only warrants loads to be sustained by jack stands that meet
current ASME standards.
DO NOT USE wood blocks or any other non-approved lifting devices for a means of lifting with the jack and or load being raised. Failure to heed these warnings
may cause injury or death.
Assembly instructions
For easiest transportation, the jack is not assembled at the time of purchase. Please refer to the instructions below to assemble your new transmission jack
stand.
Step 1 - The Base
(A) Attach the four ball bearing caster wheels to the 4 respective legs of the jack stand making sure to tighten the screws.
(B) Connect the legs with the bolts and screws provided.
Step 2 - The Cylinder
(A) Loosen the bolts on the base. Put the cylinder on the right position on the base of the stand and tighten the bolts.
Step 3 - The Saddle
(B) Slide the saddle into the ram.
2
500kg
1148mm
1965mm
580 x 580mm
WWW.BORMANNTOOLS.COM