Advertisement
2. Configure the MMIGRS2
display with MCX, EKE or
AK-PC
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products
already on order provided that such alterations can be made without subsequential changes being necessary
All trademarks in this material are property of the respective companies. Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
© Danfoss | Climate Solutions | 2021.06
After turning on and connecting the display, follow these steps:
Press and hold the X and • of the MCX keyboard
until it enters the BIOS:
If you see an "L" and the number "1" in the diagram, the display is online with the controller.
This diagram shows that the address display 126 is online with the controller address 1.
This menu shows that the display found a device on the network.
The equipment address that the display found is corresponding to the location where the number 1
appears. In image A, the equipment found is with address 1. In image B, it has address 10.
The equipment address (MCX, EKE or AK-PC can be changed).
Image A
When the previous steps are OK and the display
recognizes the controller, go to the home menu
and find the option "MCX SELECTION":
Go to the CAN sub-menu and enter "ACTIVE
NODES":
Image B
Select "MAN SELECTION" and enter the address
of the equipment to which the display is
connected (network address).
eady agreed.
AQ380717962730en-000101 | 2
Advertisement
