Table of Contents
Advertisement
2
2.2 ASSEMBLY INSTRUCTIONS
2.2.8.2 CDL / CLUTCH ADJUSTMENT
To adjust the retainer from the second interface element proceed as shown in the details. It is only necessary to
2.2.8.2.3
perform this regulation if the retainer does not actuate correctly.
AIM
0,5
Clutch / CDL base
hidden for ease
the explanation,
do not remove it
To carry on a fine tuning it's only needed to loose the two
To carry on a fine tuning it's only needed to loose the two
Loosen both screws shown in the image to perform fine tuning.
Loosen both screws shown in the image to perform fine tuning.
indicated screws without fully remove it. The clutch base hole,
indicated screws without fully remove it. The clutch base hole,
It is not necessary to fully loosen.
It is not necessary to fully loosen.
grants to move ± 25 mm.
grants to move ± 25 mm.
A
MOD MC PREMIUM PM
B
Only when a change in the support hole position is required, do
Only when a change in the support hole position is required, do
you need to fully remove the screws.
you need to fully remove the screws.
47
Advertisement
Table of Contents
