Table of Contents
Advertisement
2
2.2 ASSEMBLY INSTRUCTIONS
2.2.3 CLEAR OPENING (PL) VERIFICATION AND VALIDATION
Once the open position and the synchronization has been adjusted, proceed with the carriages in the closed
2.2.3.2
position. If the gap between carriages is not 30 mm proceed as shown below.
AIM
15
32
15
MOD MC PREMIUM PM
Adjust the rubber stops until the distance between the
Adjust the rubber stops until the distance between the
carriages and half PL (centre line) is 15 mm on each side.
carriages and half PL (centre line) is 15 mm on each side.
Advertisement
Table of Contents
