Unpacking The Fire - Supra 148C Instructions For Installation And Use Manual

3
3

Unpacking the fire

1. Unpack the fire and remove the retaining screws that are holding the 2 half-bases and 2 side cross pieces of the stand onto the pallet. These
screws will not be used again.
2. Remove the retaining screws that are holding the fixed frame onto the pallet (fires with lift-up door). These screws will not be used again. .
3. Remove the 4 screws that are holding the fire onto the transportation pallet (access underneath the pallet). These 4 screws will not be used again.
4
4
Assembly of the stand and fixing of the fire to the stand
3.4.1
3.4.2
Floor protection
A
sheet
5
5
Assembly of the warm air distribution box
Reminder
148C optional
150C
suppl i e d, to be mounted
152C
suppl i e d, to be mounted
162C suppl i e d, to be mounted
168C optional
163
suppl i e d, to be mounted
• If the warm air distribution ducts are connected up, the closable grilles must never all be closed at the same time.
• The 4 outlets must never be closed at the same time. At least two of the outlets must remain open.
• If the ducts pass through cold roof spaces, lagging must be fitted.
• Limit the number of elbows to a minimum.
• Always ensure that the outlets are placed higher than the nozzles.
• For efficient operation, the total length of the distribution ducts must not exceed:
- 6 metres for natural convection.
- 9 metres for forced convection.)
Also ensure that that the incline of the distribution ducts is always positive.
• Reminder: any warm air outlet must be at least 30 cm from the ceiling.
I
A
A
A
A
See leaflet DA 148C.
See leaflet DA 168C.
Do not tighten the screws completely (A).
UAlways use the pre-drilled hole indicated.
Reminder
148C
150C
152C
162C
168C
163
To fix the fire onto the stand, it is preferable to lay the fire
on its back, assemble the parts, tighten the screws in the
stand completely and then stand the whole assembly up.
The warm air distributor makes it possible to channel the warm air into
neighbouring rooms or upstairs. Connect each nozzle to a closable grille
(single or double), so as to be able to adjust the flow of warm air according
to the particularities of the installation. The connection is made using
flexible aluminium ducts (not supplied).
Fires 162C / 163
These appliances are equipped with a complete standard warm air distri-
butor. If you wish to heat only the room in which the fire is installed, it is
not necessary to connect up the nozzles to the openings in the hood.
W ARNING
W ARNING
GB 8/16
Screws to use
A
optional
I
suppl i e d, to be mounted
suppl i e d, to be mounted
suppl i e d, to be mounted
optional
suppl i e d, to be mounted
Screws to use
A
8 x
8 x
4 x
25254-11-08