Table of Contents
Advertisement
12
12
Installation and removal of the smoke baffle
The smoke baffle improves the exchange of heat and facilitates the recovery of soot. Before the appliance is finally put into place, it is worth
familiarising yourself with the manipulations required to install and remove this part. For optimum operation, the position given must be used.
Before sweeping the chimney, remove the baffle placed in the top of the appliance.
Fires 148C / 150C / 152C
Introduce the smoke baffle into the upper part of the fire by tilting
it. At the rear place it on the 2 hearth plate fixing screws and at
the front on the 2 lugs. It should fit up against the screws fixed on
the lugs.
3.12.1
Screw
Baffle
Hearth plate
fixing screw
13
Placing of the andirons
13
Place the andirons inside the firebox.
KTE 152 Convection accelerator (optional)
14
14
These fires may be fitted with a convection accelerator, the KTE 152, which stirs the air so that the temperature in the room is more evenly distri-
buted. This accessory must be installed and connected according to the instructions provided with the kit.
15
Connection to the smoke evacuation flue
15
This is a matter dealt with by French standard FR-DTU 24.1.
The evacuation of smoke includes the connecting pipes and the smoke flue. This installation must allow chimney sweeping and the reco-
very of soot.
The connection must be made in the room where the appliance is located by the shortest possible route, with no negative inclines and must
be visible along all its length.
It will be made using metal ducts:
- black sheet at least 2 mm thick.
-enamelled sheet at least 0.6 mm thick.
- stainless steel at least 0.4 mm thick.
- or using polycombustible rigid or flexible tubing. This type of tubing must be approved for this type of use.
- Aluminium, aluminised steel and galvanised steel are strictly prohibited.
The connection may be made according to one of the methods shown in the diagrams below.
If the draught of the smoke flue has a higher value than those recommended in Table 1, the installation of a draught regulator is obligatory.
3.15.1
Fires 162C / 168C / 163
Introduce the baffle into the fire by tilting it. At the rear place it on the hooks
situated above the hearth plate. Let it rest at the front.
3.12.2
3.15.2
GB 12/16
Déflecteur
3.15.3
Draught
Fire box
All fires
Crochet
Chimney duct
Sweeping cone
25254-11-08
Advertisement
Table of Contents
