Leak Test - Napoleon PRESTIGE PRO Series Owner's Manual

L T
EAK EST
Why and When to Leak Test?
A leak test confirms no gas is escaping after you connect
the hose to the gas supply.
Each time the tank is refilled and reinstalled, ensure
that there are no leaks in the fitting where the regulator
connects to the tank.
Leak test this grill before use, annually, and when any gas
components are replaced.
Leak Test Steps
1. Do not smoke while performing the test.
2. Remove all sources of ignition.
3. Turn all burner controls to the off position.
4. Turn the gas supply valve on.
5. Brush a half-and-half solution liquid soap and water
onto all joints and connections of the regulator, hose,
manifolds, and valves.
6. Bubbles indicate a gas leak.
WARNING! Never use an open flame to check for gas leaks. Sparks or flames will cause a fire, explosion, damage
to property, serious physical injury, or death.
WARNING! Only use the pressure regulator and hose assembly supplied with the
grill, or one in conformity with local codes.
8
| Getting Started
If you find a leak
1. Tighten any loose joints.
2. If the leak cannot be stopped, immediately shut off the
gas supply and disconnect the grill.
3. Have the grill inspected by a certified installer, or dealer.
4. Do not use the grill until the leak has been fixed.
!
Napoleon.com | PRESTIGE PRO® Series
STOP