Icom UX-9100 Service Manual page 4

SECTION 1.
• Frequency coverage
(With IC-9100)
• Antenna impedance
• Operating temperature range
• Power supply requirement (Nominal)
• Current drain
(Approximately)
• Dimensions
(Projections not
included)
• Weight (Approximate)
• Transmit output power
• Mode
• Modulation
• Max. deviation
• Spurious emission
• Carrier suppression
• Unwanted sideband
• Operating mode
• Mode
• Receive system
• Intermediate frequencies
• Sensitivity
• Squelch sensitivity
• Adjacent channel
selectivity
• Spurious & image rejection ratio
All stated specifi cations are subject to change without notice or obligation.
1
* ; Guaranteed only 1240.000000 to 1300.000000 MHz.
2
* ; The optional UT-121 is required.
SPECIFICATIONS
[KOR]
[USA], [CHN], [EXP]
[EUR], [EUR-01]
[ESP], [FRA]
[ITR]
[TPE]
RX (AF Max Power)
TX (High)
except RF-C UNIT
RF-C UNIT
SSB
AM
FM
2
DV*
FM
SSB, CW
DV
FM
SSB
FM
SSB
RX
TX
RX
TX
RX
TX
RX
TX
RX
TX
50 Ω (Nominal)
±0˚C to +50˚C (32˚F to +122˚F)
13.8 V DC ±15% (Negative ground)
142 (W) × 26 (H) × 181 (D) mm;
80 (W) × 71.3 (H) × 1.6 (D) mm; 3.1 (W) × 2.8 (H) × 0.1 (D) in
0.95 kg (2.1 Ib)
10 W (High), 1.0 W (Low)
A1A, J3E, F1B, F3E, F7W*
Digital PSN modulation
Digital Low power modulation
Digital Phase modulation
GMSK Digital Phase modulation
–50 dB min (Out-of-band domain)
More than 40 dB
More than 40 dB
Simplex, Duplex
A1A, J3E, F1B, F3E, F3E, F7W*
Triple conversion
1st IF; 243.9500 MHz, 2nd IF; 10.9500 kHz 3rd IF; 36 kHz
−15 dBμV typ. at 12 dB SINAD (Less than 0.18 μV)
−19 dBμV typ. at 10 dB SINAD (Less than 0.11 μV)
−9 dBμV typ. at 1% BER (Less than 0.35 μV)
–15 dBμ (Less than 0.18 μV) (At threshold)
+80 dBμ (Less than 10.0 mV) (At Tight)
0 dBμ (Less than 1.00 μV) (At threshold)
+80 dBμ (Less than 10.0 mV) (At Tight)
More than 15.0 kHz/6 dB
More than 2.3 kHz/6 dB
More than 50 dB
1 - 1
1260–1300 MHz
1
1240–1320 MHz*
1240–1300 MHz
1240–1300 MHz
1240–1300 MHz
1270–1298 MHz
1260–1265 MHz
5.5 A
11.0 A
5.6 (W) × 1.0 (H) × 7.1 (D) in
2
FM ±5.0 kHz
–53 dB min.
2