Makita CBU02 Instruction Manual page 7

5. Clamp the control cable to the cable holders.
2
1
Fig.6
► 1. Cable holder 2. Control cable
NOTICE:
Make sure that the control cable is
securely fixed to the cable holders.
Installing the end nozzle
Align the triangle mark on the end nozzle with that on
the swivel pipe, then attach the end nozzle to the swivel
pipe, and then turn the end nozzle to lock it into place.
Fig.7
► 1. Triangle mark 2. End nozzle 3. Swivel pipe
To remove the end nozzle, perform the installation
procedure in reverse.
1
2 3
NOTE: The length of the nozzle can be changed by
moving the nozzle as shown in the figure.
1
Fig.8
► 1. End nozzle 2. Swivel pipe
Installing the flat nozzle or
extension nozzle
Optional accessory
NOTE: If the end nozzle is installed, remove it before
installing the adapter pipe.
1. Align the triangle mark on the adapter pipe with
that on the swivel pipe, then attach the adapter pipe to
the swivel pipe, and then turn it to lock it into place.
Fig.9
► 1. Triangle mark 2. Adapter pipe 3. Swivel pipe
7 ENGLISH
2
1
2 3