Makita CBU02 Instruction Manual page 6

2. Install the control handle to the swivel pipe and
tighten the clamp screw.
1
Fig.2
► 1. Control handle 2. Swivel pipe 3. Clamp screw
NOTICE:
Be careful not to twist the cable of the
control handle when attaching the control handle
to the swivel pipe.
3. Loosen the screw on the hose clamp, and then
attach the hose clamp to the flexible pipe. Attach the
swivel pipe to the flexible pipe, and then tighten the
screw on the hose clamp.
1
Fig.3
► 1. Swivel pipe 2. Hose clamp 3. Flexible pipe
4.
attach the hose clamp to the flexible pipe. Attach the
flexible pipe to the elbow, and then tighten the screw on
the hose clamp.
2
3
Fig.4
► 1. Flexible pipe 2. Hose clamp 3. Elbow
NOTICE:
clamps are facing the direction shown in the
figure.
2 3
Fig.5
► 1. Screw
6 ENGLISH
Loosen the screw on the hose clamp, and then
1
Make sure that the screws on the hose
2 3
1