Makita VC006GM Instruction Manual page 17

Erasing all tool registrations
You can erase all tool registrations from the cleaner as follows.
2
3
Fig.35
► 1 . Stand-by switch 2. Wireless activation button
3. Wireless activation lamp
Description of the wireless activation lamp status
1
2
Fig.36
► 1. Wireless activation button 2. Wireless activation lamp
The wireless activation lamp shows the status of the wireless activation function. Refer to the below table for the
meaning of the lamp status.
Status
Color
Standby Blue
Tool Green
registration
Cancelling/ Red
erasing
(slow: 2 times/sec.)
tool
registration
Others Red
Off
1
Wireless activation lamp
Duration
(approximate)
On Blinking
Cleaner: con-
Tool: 2 hours
When the tool is
running.
20 seconds
2 seconds
20 seconds
When the wireless
activation button is
(fast: 5 times/sec.)
pressed down.
2 seconds
3 seconds
-
1. Install the wireless unit to the cleaner.
2. Install the batteries to the cleaner.
3. Set the stand-by switch to "AUTO".
4.
Hold down the wireless activation button for about
6 seconds until the wireless activation lamp blinks in red
(about twice per one second).
5. When the wireless activation lamp starts blinking
in red, release your finger from the wireless activation
button. Thereafter, hold down the wireless activation
button again for about 6 seconds.
6.
When the wireless activation lamp starts blinking
fast (about 5 times per one second) in red, release your
finger from the wireless activation button. When the
wireless activation lamp lights up in red and later lights
off, all tool registrations are erased.
NOTE: If the wireless activation lamp does not blink
in red, press the wireless activation button briefly and
try again.
Waiting for the tool registration or the wireless activation function is available.
tinuing The lamp on the cleaner blinks when the stand-by switch is set in AUTO. The
lamp on the tool blinks when the wireless activation button is pushed. The lamp
on the tool will automatically turn off when no operation is performed for 2 hours.
The wireless activation of the cleaner is available and the tool is
running.
Ready for the tool registration. Searching the tool to be registered.
The tool registration has been finished. The wireless activation
lamp will start blinking in blue.
Ready for the cancellation of the tool registration. Searching the
tool to be cancelled.
Ready to erase all tool registrations.
The tool registration has been cancelled/erased. The wireless
activation lamp will start blinking in blue.
The power is supplied to the wireless unit and the wireless activa-
tion function is starting up.
- The stand-by switch is not set to "AUTO".
17 ENGLISH
Description