Seco i-PAN T10 Baseboard Manual page 9

J217: iMod Button/I2C or UART connector
The iMod connectors are standard connectors defined by SECO to allow customers to easily
add functions to a baseboard.
There are two mounting options for J217:
a) iMod Button/I2C
The connector got 3 GPIOs for buttons and an I2C-interface for sensors etc.
Pin
1
2
3
4
5
6
7
8
9
10
Connector: 687110149022 by Wuerth
Version 2.0
Signal
FASTBOOT
SP113
SP117 Generic Button, i.e. Volume-
GND
+3V3
I2C_CLK
I2C_DATA
SP119 GPIO; Mainly used as interrupt input pin by attached
SP112
\RESET_OUT Reset output of the Trizeps module:
Low during reset and suspend.
i-PAN T10 Baseboard
Function
On/Off, Fastboot, ... (OS-specific)
Generic Button, i.e. Volume+
(opt. RESET_IN of Trizeps module)
Power
Power
I2C Clock signal
I2C Data signal
boards.
GPIO; Mainly used as output.
High when running.
9 of 20