Internal Connectors - Seco i-PAN T10 Baseboard Manual

3 INTERNAL CONNECTORS

J303: iMod USB/I2C connector
The iMod USB/I2C connector is a standard connector defined by SECO to allow customers to
easily add functions to a baseboard.
SECO offers different extension boards ranging from a simple breakout board or an additional
USB-type A connector to current-, voltage-, TOF-, NFC- sensors or IO-expander boards.
Customers may design their own peripherals which can be connected through a 10pol FFC
cable.
Pin
1
2
3
4
5
6
7
8
9
10
Connector: 687110149022 by Wuerth
The USB-OTG port of the Trizeps module is used by this connector.
This interface may be used as USB-Slave, USB-Host or real USB-OTG port. Actual function
depends on Trizeps module and operating system.
Note that the USB-OTG port is also connected to the Micro-USB connector J501.
Only one of both connectors can be used at the same time!
The +5V power-supply-pin is not over-current protected.
Version 2.0
Signal
+5V
USB_DM
USB_DP
GND
+3V3
I2C_CLK
I2C_DATA
GPIO_00 GPIO; Mainly used as interrupt input pin by attached
GPIO_AUX
\RESET_OUT Reset output of the Trizeps module:
Low during reset and suspend.
i-PAN T10 Baseboard
Function
Power
USB D- signal
USB D+ signal
Power
Power
I2C Clock signal
I2C Data signal
boards.
GPIO; Mainly used as output.
High when running.
7 of 20