Seco i-PAN T10 Baseboard Manual page 11

J305: iMod CAN connector
The iMod CAN connector is a standard connector defined by SECO Northern Europe to allow
customers to easily add a CAN transceiver & connector to the baseboard.
Pin
1
2
3
4
5
6
7
8
9
10
Connector: 687110149022 by Wuerth
The CAN_TX and CAN_RX are single-ended 3V3-level signals.
A CAN-transceiver is needed to convert these to a differential CAN signal.
CAN_GPIO signals may be used for auxiliary functions, i.e. enabling CAN-termination.
J200: Trizeps VII SODIMM connector
This SODIMM200 Trizeps connector can be populated with different Trizeps modules.
Although earlier and future Trizeps products will fit too, currently only Trizeps VII modules are
shipped with i-PAN T10.
Functionality of the whole i-PAN T10 varies depending on which Trizeps module is inserted!
(i.e. processing speed, RAM, Wifi and Bluetooth, audio ...)
For the actual pinning of this connector refer to the Trizeps VII datasheet.
J201: Trizeps VII High Speed connector
For the actual pinning refer to the Trizeps VII datasheet.
This connector carries the MIPI camera signals which are routed to the Raspberry Pi compatible
camera connector J218 and the LVDS display connector J301.
Version 2.0
Signal
+5V
CAN_GPIO2
CAN_GPIO3
GND
+3V3
CAN2_TX
CAN2_RX
CAN1_TX
CAN1_RX
CAN_GPIO0
i-PAN T10 Baseboard
Function
Power
Generic GPIO
Generic GPIO
Power
Power
Single ended TX output of CAN port 2
Single ended RX input of CAN port 2
Single ended TX output of CAN port 1
Single ended RX input of CAN port 1
Generic GPIO
11 of 20