User Connectors - Seco i-PAN T10 Baseboard Manual

2 USER CONNECTORS

J400: Power connector
Pin
1
2
Connector:
PTSM 0,5/2-HH-2,5-SMD by Phoenix Contact (1778764)
Mating Connector:
PTSM 0,5/2-P-2,5 by Phoenix Contact (1778832)
PTSM 0,5/2-PL-2,5 by Phoenix Contact (1709457) (incl. locking)
The panel can be either powered by this connector or optional through POE (Power-Over-
Ethernet, J500/J503).
Voltage polarity protection is achieved through a diode.
A Nanofuse (near to J400) is used for current protection.
There is an option to mount a Wago 231-532/001-000 instead of the Phoenix PTSM connector.
J306: Headset 3.5mm Audio Jack (CTIA)
The 3.5mm audio-jack is using the commonly used CTIA pinning, so that a standard headphone
or headset can be attached to the panel.
The signals are shared with the solder pads J213 (Headphone_L), J214 (Headphone_R), J212
(Headphone_Gnd) and J215 (Mic).
Headphone_L and Headphone_R of this connector are also connected to an internal audio-
amplifier, which outputs to the speaker solder pads J205/J206.
Connector: SJ43514-SMT by Kycon
J501: µUSB connector
Connector: SD-47346-001 by Molex
The USB2.0 Micro-USB connector is routed to USB-OTG port of the Trizeps module.
Function depends on the placed Trizeps module and operating system.
This interface may be used as USB-Slave, USB-Host or real USB-OTG port.
Note that the USB-OTG port is also connected to the iMod USB/I2C connector J303.
Only one of both connectors can be used at the same time!
Version 2.0
Signal
VIN (+9V up to +24V)
GND
i-PAN T10 Baseboard 5 of 20