Installing The Nozzle - Makita DUB187 Instruction Manual

17. Unless the tool supports the use near
high-voltage electrical power lines, do not use
the battery cartridge near high-voltage electri-
cal power lines. It may result in a malfunction or
breakdown of the tool or battery cartridge.
18. Keep the battery away from children.
SAVE THESE INSTRUCTIONS.
CAUTION:
Only use genuine Makita battery
cartridges. Use of non-genuine Makita battery car-
tridges, or battery cartridges that have been altered,
may result in the battery bursting causing fires, per-
sonal injury and damage. It will also void the Makita
warranty for the Makita tool and charger.
Tips for maintaining maximum
battery life
1. Charge the battery cartridge before completely
discharged. Always stop tool operation and
charge the battery cartridge when you notice
less tool power.
2. Never recharge a fully charged battery car-
tridge. Overcharging shortens the battery
service life.
3. Charge the battery cartridge with room tem-
perature at 10 °C - 40 °C (50 °F - 104 °F). Let
a hot battery cartridge cool down before
charging it.
4. When not using the battery cartridge, remove
it from the tool or the charger.
5. Charge the battery cartridge if you do not use
it for a long period (more than six months).
ASSEMBLY
CAUTION:
Always be sure that the machine is
switched off and the battery cartridge is removed
before carrying out any work on the machine.
Installing or removing the wheels
To install the wheels, insert the claw of the wheels into
the slot of the nozzle as shown in the figure.
Fig.1
► 1 . Claw 2. Slot
1 2
To remove the wheels, slide the claw upward slightly,
and then remove the wheels.
Fig.2
► 1 . Claw

Installing the nozzle

Loosen and remove the screw of the main unit. Align the
protrusions on the nozzle with the grooves on the main
unit, then insert the nozzle into the main unit until the
protrusions snap into place. Tighten the screw securely
to fix the nozzle.
Fig.3
► 1 . Screw 2. Nozzle 3. Protrusion
6 ENGLISH
1
1
3
2