Changing The Nozzle; Troubleshooting - Makita PM001GZ Instruction Manual

Clean the filter with running water.
3.
Attach the filter to the main unit, and then tighten
4.
the filter cap.
5. Open the tank lever.
Storage
Before storing the machine, perform full maintenance.
Store the machine in a place out of the reach of children
and not exposed to moisture, rain, or direct sunlight.
You can connect the band of the pipe to the machine as
shown in the figure to stand up the pipe.
► Fig.36: 1. Band

Changing the nozzle

You can change the standard nozzle to the ULV (Ultra
Low Volume) nozzle. The ULV nozzle can discharge
finer mist than the standard nozzle. To change the
nozzle, follow the steps below.

TROUBLESHOOTING

Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the man-
ual, do not attempt to dismantle the machine. Instead, ask Makita Authorized Service Centers, always using Makita
replacement parts for repairs.
State of abnormality
Motor does not run.
Motor stops running after a little use.
Mist is not discharged.
The machine does not reach the
maximum speed.
Abnormal vibration:
stop the machine immediately!
Motor cannot stop:
Remove the battery immediately!
Probable cause (malfunction)
Battery is not installed.
Battery problem (under voltage)
The drive system does not work
correctly.
Battery's charge level is low.
Overheating.
Tank is empty.
Nozzle lever or tank lever is closed.
Nozzle is clogged.
Filter is clogged.
Battery is installed improperly.
Battery power is dropping.
The drive system does not work
correctly.
The drive system does not work
correctly.
Electric or electronic malfunction.
22 ENGLISH
Loosen the screw and remove it, and then remove
1.
the front side of the end nozzle.
► Fig.37: 1. Screw 2. End nozzle
Remove the standard nozzle by turning the nozzle
2.
counterclockwise using the wrench.
► Fig.38: 1. Wrench 2. Standard nozzle
Remove the O-ring from the standard nozzle, and
3.
then attach it to the ULV nozzle.
► Fig.39: 1. O-ring 2. Standard nozzle 3. ULV nozzle
Attach the ULV nozzle by turning the nozzle clock-
4.
wise using the wrench.
► Fig.40: 1. Wrench 2. ULV nozzle
NOTICE:
Do not tighten the nozzle too much.
The recommended tightening torque is approxi-
mately 1.0 N•m. Tightening the nozzle too much may
damage the mounting part for nozzle.
Attach the end nozzle, and then tighten the screw.
5.
► Fig.41: 1. Screw 2. End nozzle
Remedy
Install the battery.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.
Recharge the battery. If recharging is not effective,
replace battery.
Stop using the machine to allow it to cool down.
Fill the tank with liquid.
Open the nozzle lever and tank lever.
Remove the standard nozzle or ULV nozzle, and
then clean the nozzle with running water to remove
the clogged material.
Remove the filter, and then clean the filter with
running water to remove the clogged material.
Install the battery as described in this manual.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.
Ask your local authorized service center for repair.
Remove the battery and ask your local authorized
service center for repair.