Advanced Bionics Precision SCS Handbook page 36

4. Locate the Charger over the implant. When aligned with the implant, the beeping will stop.
Secure the Charger over the implant either by pressing the adhesive side to the location, or by
attaching the Velcro
Note: If you accidentally locate the patch in the wrong place, or if the Charger moves out of
alignment, the Charger will start beeping again. Use a new adhesive patch or readjust the
®
Velcro belt to place the Charger back to position.
5. When the Charger emits a distinct double
beep, the implant is charged. Switch off the
Charger, remove the adhesive patch or
®
Velcro belt, and return the Charger to the
Base Station.
Do not confuse the end of charge (a distinct
double beep) signal with the steady, contin-
uous misalignment signal.
®
belt.
Charging the Implant
31