Table of Contents
Advertisement
Patient System Handbook
To replace the Remote Control battery
1. On the rear of the remote, slide the battery
compartment lock lever to the left to unlock
the cover.
2. Press down on the ridged area below the
lever using your thumb to release the cover.
3. Open the cover and remove the old battery.
4. Replace the new battery in the slot,
matching the positive (+) and negative (-)
markings.
5. Close the compartment by sliding the lock
lever to the right.
The Remote Control will connect and reload information from the implant in approximately 30
seconds.
26
Advertisement
Table of Contents
