Page 1
SERVICE BULLETIN SB2015 REV. F 8/11 ® PREMIUM SERIES HOSE REELS 2111-XXX Multi-Purpose Dispense Model Mount Style 2111-XXX Ceiling 2111-XXXS Side/Wall 2111-XXXB Base See page 3 for Hose Reel Model Numbers and Technical Data 2111-XXXB 2111-XXXS Thoroughly read and understand this manual before installing, operating or servicing this equipment.
Product Description Be aware of possible fluid thermal expansion! A pressure relief valve should be properly installed in he Heavy Duty Premium Series hose reel is designed for service where larger volumes of any system where this product is used. Should this deliveries are required.
Model Numbers NOTE (1): Inlet hoses are included with Premium Series Open Max. Type of Model Outlet Inlet Bare Hose Size Working Service Hose Hose Reel Pressure 2111-014 40’ x 3/8” 300 PSI 8136-030 8141-002 2111-024 Pressure 2111-015 50’ x 3/8”...
Installation 2. Locate the mounting holes for drilling, using measurements on previous page. If mounting Tank/Wall Mounting: directly to I-Beam use mounting kit 2230-013 (no The hose reel has been shipped for a ceiling mount drilling required). application unless specified differently. The outlet 3.
Page 5
Installation WARNING: Wear Heavy Leather Increasing Power Spring Tension: Gloves when replacing service hose and/or 1. Pull the hose out fully and engage the stop replacing power spring to protect your hands from pawl. injury. 2. Be sure the system pressure has been relieved. Follow the pressure relieve procedures below.
Base Mounting Position: 2111-XXXB Replacing the Swivel: The hose reel is shipped ready to use. No assembly is required for basic operation. (See figure 3) 1. Be sure the pressure supply has been relieved, when replacing the swivel. Follow the pressure relieve procedures below.
Page 7
Maintenance 7. Be sure case is laying flat on the work surface, now remove bolts (23). Then using Replacing Power Spring: extreme caution, remove both safety cotter 1. Be sure the pressure supply has been pins (17) from sides of case and lift up on the relieved when.
Page 8
Replacing Power Spring continued Hose Clamps Power Spring Vise Grip Pliers Power Spring Keeper (Safety Ring) Spring Case Figure 5 Figure 6 Keeper & Safety Clamps Power Spring Removal Using Locking Pliers Premium Reel 6.17 Mounting Footprin 4.84 3.90 2.27 1.34 R.22 11.00...
Doing so may cause spring (8) and snap ring (26). Once this has damage to reel and/or personal injury. been done the complete assembly can be Always use genuine Balcrank replacement removed. parts. 3. Item (27) bronze bearing will need to be NOTE: Number with “*”...
Page 11
Ceiling (-XXX) & Base (-XXXB) Side (-XXXS) models models Parts Listing for Premium Series (BARE) Reels ITEM PART DESCRIPTION 805743* PIN, COTTER, 3/32 X 3/4* 831729 SPACER, WITH SHOULDER 812114 RATCHET/HP 808945 RATCHET/L&MP 812113 HUB/HP 828173 HUB/L&MP 832319 COVER, SPRING CASE...
Page 12
For Warranty Information Visit: www.balcrank.com Revision Log: Rev. A - Release 9/07 Balcrank Corporation Rev. B - Removed models 2111-001, -005, -009, -013, & -017. Added models 2111-002 Weaverville, NC 28787 -006, -010, -014, & -018. 800-747-5300 Rev. C - Added mounting footprint to page 8 800-763-0840 Fax Rev.