Wiring Diagram - Valet System One MINI Installation Manual

WIRING DIAGRAM

DOOR
STRIKE
AUTOMATIC
GATE
PLUG
PACK
ROOM
STATION
ROOM ROOM
STATION STATION
ROOM
STATION
POWER
SUPPLY SUPPLY
INPUT JACK
INPUT JACK
TYPE B TYPE B
*
NOTE: Single core cable not required if Aux/Lock boards not used
INPUT JACK DOOR
TYPE B STRIKE
ROOM ROOM
STATION STATION
POWER
SUPPLY
*
NOTE: Single core cable not required if Aux/Lock boards not used
MECHANICAL
CHIME
ROOM
STATION
ROOM DOOR DOOR
STATION STATION
ROOM
STATION
VALET INTERCOM CABLE
FIGURE 8 CABLE
SINGLE CORE CABLE
PLUG
PACK
ROOM DOOR
STATION STATION
VALET INTERCOM CABLE
FIGURE 8 CABLE
SINGLE CORE CABLE
INSTALLATION OF DOOR STATIONS
INSTALLATION OF DOOR/GATE
STATIONS
Depending on the type of wall to
which the station is to be affixed
i.e. timber or brick, door station
housing DSH may be needed.
Where stations are exposed to
extreme weather, a weather proof
cover should be fitted.
Green and orange wires are not
used at door station. Tape green
and orange wires back to white
outer sheath of valet cable.
Do not connect green and orange
wires of door station cable at room
station end. Tape back in same
manner as above.
Where a door station is part of a
wiring loop, the door station should
always be the last station on the
loop.
Green and Orange to be taped back
at this end and also at other end.
U5
RED
POS
BLACK
NEG
WHITE
COM1
VR1
BLUE
COM2
VR2
DOOR STATION - CABLE TERMINATION
INPUT JACK
NOTE: For 6 Wire Systems
- Connect Green & Orange of
input jack to Com1 (White) an
Com2 (Blue) of room station.
- Fit jumper to L1
ORG
MUS2 (ORANGE)
GRN
MUS1 (GREEN)
YEL
VLC (SHIELDED WHITE)
GRY
TC (SHIELDED RED)
BLK
L1 NEG (BLACK)
. .
RED
POS (RED)
NOTE: For 6 Wire Systems
- Connect Green & Orange of
input jack to Com1 (White) and
Com2 (Blue) of room station.
- Fit jumper to L1
GREEN
ORANGE
VR3
SHIELDED WHITE
TC
SHIELDED RED
VLC
OUTER SHIELD
SHLD
CH
NOTE: Outer shield should
be insulated.
SEL
PROG