Advertisement
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
No parts required
Auxiliary valve
Bracket
Bolts (M8)
90-degree fitting (1/2-inch male, 5/8-inch
male)
Cover
Clip nut
Bolts (M6)
90-degree fitting (5/8-inch male, male)
90-degree fitting (5/8-inch male, 5/8-inch
female)
Tee fitting
Hydraulic hose (30 inches)
Directional valve assembly
Bolts (5/16 inch)
Washer
Short Hydraulic tube
Long hydraulic tube
Hydraulic hose (24 inches)
90-degree fitting (5/8-inch male, 3/4-inch
female)
Decal
Cable ties
Preparing the Machine
1. Move the machine to a level surface.
2. Set the parking brake and lower the attachments to
the ground.
3. Shut off the machine and remove the key.
4. Remove the bolts and cover from the existing bulkhead
mount as shown in Figure 1.
Qty.
–
Prepare the machine.
1
1
Install the auxiliary valve.
3
2
1
3
3
2
1
Install the directional valve cover and assembly.
1
1
1
2
2
1
1
1
Install the hydraulic hoses and the decal.
2
1
2
1
2
1. Bolts
2
Use
g027024
Figure 1
2. Cover
Advertisement
