Garden Wood Furniture Somerset 961W2 Assembly Instructions Manual page 4

A
x4
C
x8
A
3) Glue 10x40mm Wood Dowels (C) in the two outer holes in the three-hole groups in the Left
and Right Glider Leg Assemblies (7&8). Attach the Glider Leg Supports (9) to the Left Glider
Leg Assembly (7) with Dowels (C) and 7x70mm Hex Screws (A). Attach the Right Glider Leg
Assembly in the same way. The front leg support will not touch the ground. This is to allow for
any unevenness of the ground between the legs.
E
x8
F
x16
G
x8
4) The Rocker Arms (I) are not straight, but are slightly bent so that the attachment holes on
each end will be flush against the glider legs and bench legs. Insert a 6.5x50mm Hex Bolt (E)
through a Washer (F) and the hole in the front lower corner of the Left Leg, another Washer,
and onto a Rocker Arm (I). Attach a Hex Nut (G)and tighten. Repeat for the right front leg and
do the back legs.
Insert a 6.5x50mm Hex Bolt (E) through a Washer (F), the hole in the left front glider leg,
another washer and the Rocker Arm. Attach Hex Nut (G) and tighten. Repeat for the other
rocker arms.
BACK
C
C
A
A
C
C
FRONT
FIG. 3
F
E
FIG. 4
A
A
F
E
F
G
G I
F
E
961W2 – Page 4
K
K