Tools Required - Garden Wood Furniture Somerset 961W2 Assembly Instructions Manual

ASSEMBLY INSTRUCTIONS
Phillips Screwdriver, Adjustable Wrench, Mallet or Padded Hammer, Outdoor Wood Glue.
H
A
x6
x2
A
C
x6
D
x2
1) Glue three 10x40mm Wood Dowels (C) into the upper hole in each pair of holes in the Left
and Right Leg Assemblies (1&2). Glue a 8x30mm Dowel (D) in upper hole in each end of
Seat Brace (6).
Note that one end of Seat Brace is square and the other is angled. Attach the Back (3) to the
angled end of the Seat Brace with a dowel and a Phillips Screw (B) through the pocket drilled
hole in the brace. The curved surface of the Seat Brace must face up.
Attach the Front Apron (4) to the square end of the Seat Brace in the same way.
Attach the Back/Seat Brace/Front Apron assembly to the Left Leg Assembly (1) with dowels
and 7x70mm Hex Screws (A). Repeat with the Right Leg Assembly (2).
Tap Metal Pin (H) into the hole in the inside front edge of the Left and Right Leg Assemblies
(1&2) near the bottom. These pins are to act as a stop for the Rocker Arm and prevent the
glider form tipping too far backward.
x9
2) Slip the Seat (5) between the legs onto the seat braces. Insert two Phillips Screws (B) in the
predrilled holes in each outer seat brace and fasten to both leg assemblies. Insert a Phillips
Screw (B) through each hole in the bottom of the center seat brace into the slats.
961W2 Somerset Glider 44"

TOOLS REQUIRED:

x2
C
C
A
A
C
C
D
D
B B
C
H
B
B B B B B
A
A
A
C
H
FIG. 1
B
FIG. 2
K
A
961W2 – Page 3