Table of Contents
Advertisement
Using the product with the ATDM series DIGITAL SMARTMIXER™
Use the latest firmware for the ATDM series DIGITAL SMARTMIXER
1. Connect Mic 1-4 of the product to input 1-4 on the ATDM series DIGITAL
TM
SMARTMIXER
. Launch Web Remote, select "Administrator", and log in.
• When using two units of the product with ATDM-1012/ATDM-1012DAN at the
same time, connect INPUT 1 to 4 and INPUT 6 to 9.
2. Click the icon (
) on the top right of the screen then select "System Settings" >
"Audio". Activate "Virtual Mic Mode". This automatically sets the input type of input
channels 1 to 4 of the ATDM series DIGITAL SMARTMIXER
• For input channels other than "Virtual Mic" which is automatically selected by
default, you can also select "Virtual Mic" and make the same settings.
About Operator Access / Operator Page in Settings &
Maintenance
When "Virtual Mic Mode" and "Array Mic Switch" are enabled, an array mic mute
ON/OFF button appears on the operator page. The microphone can be muted on the
operator page.
• This setting is not saved on the device, so rebooting the ATDM series DIGITAL
TM
SMARTMIXER
restores it to its default position.
Administrator page's input tab on the main screen
1. In the Input tab, check that the input type for input channels 1-4 is set to "Virtual
Mic".
• For input channels other than "Virtual Mic", which is automatically selected by
default, you can also select "Virtual Mic" and make the same settings.
2. Adjust the gain to the required level (a).
• Setting the input gain on one channel will simultaneously change it on all four
channels. Low cut, EQ, Smart Mix and output bus assign can individually be
assigned for each channel.
3. Clicking "Pattern" of the Virtual Mic box (b) opens the settings tab for the directivity
pattern. These can be adjusted between "Normal" (hypercardioid) , "Wide" (cardioid)
and "Omni".
4. Clicking the blue button around the circle sets the orientation of each Virtual Mic.
5. Adjust the Virtual Mic direction towards the talker to be picked up.
• The Audio-Technica logo is located on the front of the microphone. The
microphone must be oriented correctly to operate properly.
6. Using the "Tilt" function, you can adjust the directivity on the vertical plane to adjust
the angle depending on whether the talker is sitting or standing.
7. Adjust the individual volume of each Virtual Mic using the Volume Fader.
TM
.
TM
to "Virtual Mic".
6
(a)
(b)
Advertisement
Table of Contents
