Hilti NURON TE 5-22 User Manual page 15

5.6 Removing the depth gauge
1. Press and hold down the release button on the auxiliary handle.
2. Pull the depth gauge out of the mount for depth gauge on the auxiliary handle.
3. Let go of the release button on the auxiliary handle.
5.7 Changing the accessory tool
CAUTION
Risk of injury by the accessory tool! The accessory tool might be hot or have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
Lightly grease the connection end of the accessory tool before inserting it.
Use only genuine Hilti grease, to prevent damage to the product.
1. Pull the locking sleeve back and remove the accessory tool.
2. Insert the accessory tool into the tool holder (SDS).
3. Turn the accessory tool and push it into the tool holder (SDS) until it engages with an audible click.
▶ The accessory tool is locked.
4. Check that the accessory tool is securely locked.
5.8 Installing dust collection module for overhead work (accessory)
1. Insert the retaining lugs of the dust collection module into the connections for the dust collection module.
2. Turn the dust collection module counter-clockwise.
▶ The dust collection module is locked.
5.9 Fitting the dust removal module (accessory)
1. Move the forward/reverse switch on the rotary hammer drill to the middle position.
2. Remove the depth gauge. → page 9
3. Turn the auxiliary handle to a position where it is not in the way.
4. Hook the dust removal module into the locking pins on the rotary hammer drill.
When hooking the module into position, be sure to pass the accessory tool of the rotary hammer
drill through the extraction head of the dust removal module.
5. Press the electrical interface into the rotary hammer drill until the dust removal module engages with an
audible click.
6. Check that the dust removal module is correctly engaged.
5.10 Removing dust removal module (accessory)
1. Move the forward/reverse switch on the rotary hammer drill to the middle position.
2. Press and hold down the catch on the dust removal module.
3. Pull the electrical interface out of the rotary hammer drill.
4. Unhook the dust removal module from the locking pins on the rotary hammer drill.
5.11 Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
Comply with the national regulations for working at heights.
*2351801*
4
6
7
2351801
5
English 9