Table of Contents
Advertisement
During the moving phase (on the ground):
Cautiously move the machine avoiding sudden manoeuvres;
DO NOT TRANSPORT PERSONS on the base frame of the machine and in any other
position except for in the work position inside the platform;
Check the structural condition and cleanliness of the surfaces on which the machine is used
(verify the surface is suitable for the weight of the machine in work conditions).
During the ascent and descent phase:
Observe the maximum admissible capacity weights for the work platform;
Ascertain overhead obstacles are not present along the trajectory, in vertical;
Do not induce dangerous vibrations and/or oscillations such to entail stability loss of the machine
and cause an eventual overturning.
THE MACHINE IS WITHOUT AN AUTOMATIC BASE LEVELLING VERIFICATION SYSTEM.
BEFORE PROCEEDING WITH THE ASCENT/DESCENT PHASE, VERIFY CORRECT
INCLINATION OF THE BASE BY VISUALLY CHECKING THE SPIRIT LEVELS.
THE SPIRIT LEVELS MUST BE CENTRAL COMPARED TO THE INDICATOR, WITHIN THE
INSTALL THE STABILISING FEET IN ORDER TO REACH THE MACHINE'S MAXIMUM
INSERT THE STABILISERS INTO THE APPROPRIATE SEATS (UNTIL THEY STOP) AND
BLOCK THEM BY INSERTING THE SUPPLIED SAFETY PIN.
LEVEL THE BASE BY ADJUSTING THE STABILISER'S FEET. PAY THE UTMOST
ATTENTION WHEN SLIGHTLY LIFTING THE MACHINE'S WHEELS SO THAT THEY ONLY
1
2
AERIAL PLATFORM ELEVAH 70 - Rev. 04_2020
ATTENTION
TOLERANCE LIMITS.
ATTENTION
WORKING HEIGHT
REST ON THE STABILISER'S FEET.
INSERTION AND LOCKING OF 4 STABILISER FEET
3
USE AND MAINTENANCE MANUAL - SECTION 3
4
Page 3-4
Advertisement
Table of Contents
