Switching Off The Engine - Ford FOCUS 2014 Owner's Manual

Hide thumbs Also See for FOCUS 2014:
Table of Contents

Advertisement

Starting and Stopping the Engine
Regeneration
WARNING
Do not park or idle your vehicle over
dry leaves, dry grass or other
combustible materials. The DPF
regeneration process creates very high
exhaust gas temperatures and the exhaust
will radiate a considerable amount of heat
during and after DPF regeneration, and
after you have switched the engine off.
This is a potential fire hazard.
CAUTION
Avoid running out of fuel.
Note: During regeneration at low speed or
engine idle, you may smell a hot metallic
odor and could notice a clicking metallic
sound. This is due to the high temperatures
reached during regeneration and is normal.
Note: After you have switched your engine
off the fans may continue to run for a short
period of time.
Unlike a normal filter which requires
periodic replacement, the DPF has been
designed to regenerate, or clean itself to
maintain operating efficiency. The
regeneration process takes place
automatically. However, some driving
conditions mean that you may need to
support the regeneration process.
If you drive only short distances or your
journeys contain frequent stopping and
starting, where there is increased
acceleration and deceleration, occasional
trips with the following conditions will
assist the regeneration process:
Focus (CD3) , enPHI, Edition date: 01/2014
Drive your vehicle at a constant speed,
preferably on a main road or highway,
for up to 20 minutes.
Avoid prolonged idling and always
observe speed limits and road
conditions.
Do not switch off the ignition.
Use a lower gear than normal to
maintain a higher engine speed during
this journey, where appropriate.

SWITCHING OFF THE ENGINE

Vehicles with a turbocharger
CAUTION
Do not switch the engine off when it
is running at high speed. If you do, the
turbocharger will continue running
after the engine oil pressure has dropped
to zero. This will lead to premature
turbocharger bearing wear.
Release the accelerator pedal. Wait until
the engine has reached idle speed and then
switch it off.
119

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents