Ford FOCUS 2014 Owner's Manual page 104

Note: Avoid adjusting the settings when
the vehicle interior is extremely hot or cold.
The automatic climate control adjusts to
the current circumstances automatically.
For the system to function properly, the side
and center vents should be fully open.
Note: The sunload sensor is located on top
of the instrument panel. Do not cover the
sensor with any objects.
Note: At low outside temperatures, when
the system is in auto mode, the air stream
will be directed to the windshield and the
side windows as long as the engine is cold.
Setting the temperature
E133115
You can set the temperature between
15.5°C (60°F) and 29.5°C (85°F) in steps
of 0.5°C (1°F). In position LO, 15°C (59°F),
the system will switch to permanent
cooling. In position HI, 30°C (86°F), the
system will switch to permanent heating.
Note: If either position LO or HI is selected,
the system will not regulate a stable
temperature.
Mono mode
In mono mode, the temperature settings
for both the driver's and passenger's side
are linked. If you adjust the temperature
using the rotary control on the driver's side,
the settings will be adjusted to the same
setting on the passenger's side. In mono
mode, MONO appears in the display.
Focus (CD3) , enPHI, Edition date: 01/2014
Climate Control
To switch mono mode off
Select a temperature for the passenger's
side with the rotary control on the
passenger's side. Mono mode will switch
off and MONO disappears from the
display. The temperature for the driver's
side will remain unchanged. You can now
adjust the driver and passenger side
temperatures independently of each
another. The temperature settings for each
side are shown in the display. You can set
a temperature difference of up to 4°C
(8°F).
Note: If you set a temperature difference
of greater than 4°C (8°F), the temperature
on the other side will be adjusted so that
the difference remains 4°C (8°F).
Note: If you set one of the sides to HI or LO,
both sides will be set to HI or LO.
To switch mono mode back on
E133120
To switch mono mode back on, press and
hold the AUTO button. MONO reappears
in the display and the passenger's side
temperature will be adjusted to the driver's
side temperature.
Blower
Use the buttons to adjust the blower
speed.
The blower setting is indicated in the
display.
To return to auto mode, press the AUTO
button.
102