Elation KL PAR FC User Manual page 11

F I X T U R E I N S TA L L AT I O N
CLAMP INSTALLATION
This device features a mounting clamp attachment point built into the mounting bracket, as
well as two safety cable attachment points located on the rear face of the fixture on either
side of the control panel (see the illustration below). When mounting the fixture to a truss or
any other suspended or overhead installation, be sure to secure an appropriately rated clamp
(not included) to the clamp attachment point and attach a separate SAFETY CABLE of the
appropriate safety rating to the safety cable rigging point.
ALWAYS ATTACH A SAFETY CABLE WHENEVER INSTALLING THIS FIXTURE IN A
SUSPENDED ENVIRONMENT TO ENSURE THAT THE FIXTURE WILL NOT FALL IF
THE CLAMP FAILS.
RIGGING
Overhead rigging requires extensive experience, including but not limited to: calculating
working load limits, understanding the installation material being used, and periodic safety
inspection of all installation material and the fixture itself. If you lack these qualifications,
do not attempt to perform the installation yourself. Improper installation can result in bodily
injury.
11