Riverside Furniture Somerset Lane 16248 Assembly Instructions

Riverside
Furniture
Components packed in the 16248 Carton (below)
Table Leaf
Table Top
1 pc.
A B
Components and hardware packed in the 16249 Carton (below)
5
Flat Washer
Ø -18 x 1-1/2"
16
Allen Head
Ø
Bolt
F
8 pcs.
E
Pedestal Leg Table Base
K
2 pcs.
J
Be sure to check all packing material carefully for small parts, which may have come loose inside the
carton during shipment. Separate, count and check all parts against the Parts List and Hardware List
above. Failure to use the correct length bolts in the proper locations may result in an unsafe product and
could also cause damage to the parts being assembled.
STEP 1: Place the Table Top (A) upside down on a clean, soft surface such as a blanket or carpet, or its
own packing material. Using the Allen Wrench (H) remove the Bolts and Washers attaching the
Lower Bridge Panels (D) to the bottom side of the Table Top. Lay the Bolts and Washers aside to
reuse.
STEP 2: Attach the Lower Bridge Panels to the top end of the Pedestal Legs (J) using the 1-1/2"
Allen-Head Bolts (E), Spring Washers (G) and Flat Washers (F). Tighten with the Allen Wrench.
D
Somerset Lane
Dining Room
Assembly Instructions
Upper Bridge Panel
(attached)
C 2 pcs.
1 pc.
Spring Washer
5
Ø
x 19 x 2mm
16
16 pcs. G
2 pcs.
H
Step 1
Lower Bridge Panel
(attached)
D 1 pc.
Allen Wrench
5
5mm
x 12 x 3mm
16
16 pcs.
H
J
Step 2
Page 1 of 2
16248
Pedestal Dining Table - Top
16249
Pedestal Dining Table -
Pedestal Base
5
Ø -18 x 2"
16
Allen Head Bolt
1 pc.
I
E
G
D
J
Made in Vietnam
8 pcs.