Table of Contents
Advertisement
Glass Door
Model
Figure 3
Solid Door
Model
Figure 4
Start Your Appliance
Please observe the following options when starting your
appliance during initial plug-in.
1) If Sentry System™ LED is flashing amber (see Figure 3
or 4) the appliance is on. Simply press and release "ON/
OFF" button to stop the flashing LED.
2) If the interior light is working but Sentry System™ display
is blank push and hold "ON/OFF" button for five (5)
seconds to start the appliance.
Once loaded allow at least 48 hours for the unit to stabilize
before making any adjustments to the initial temperature
setting.
Set Your Temperature Mode
This product can display either Fahrenheit or Celsius. To
do so, press the "
F/C" button on the display panel.
°
Viewing and Changing Current Temperature Settings
The temperature set point is initially set in the factory at 55
degrees F. The available temperature range of the unit is
from 40 to 65 degrees F (4 to 18 °C). .
To view the set point push the "SET" button once and the
word "SET" and the current set-point will be displayed.
While "SET" icon is displayed push the "WARMER" or
"COLDER" button for your desired temperature. Push the
"SET" key to exit set-point mode and activate your new
temperature settings, or after 10 seconds the new settings
will automatically be activated.
As with any refrigeration product, there is a slight tempera-
ture variance at different locations within the cabinet.
Interior Light and Switch
The interior light makes it easy to view the contents of your
refrigerator. Pressing the "LIGHT" key toggles between 2
modes of operation for the internal lights: functional (de-
fault) mode and showcase mode. If you are in functional
(default) mode, the lights will turn on only if the door is
open. If you are in showcase mode, the lights will be on
whether or not the door is open.
Warning Alarms
Your refrigerator has been fitted with a Sentry System™
refrigeration monitor. This monitor will let you know if your
refrigerator is not functioning properly for optimum storage
and will alert you in the unlikely event there is an unstable
condition.
USING YOUR Sentry System™ CONTROL
Door Ajar Alarm
If the door has been left open for over five (5) minutes, the
alarm will sound and the LED will flash green. This will
stop as soon as the door is closed.
High and Low Temperature
If your unit reaches temperatures outside normal operating
temperatures for your set point for more than one (1) hour,
an alarm will sound and the LED will flash red. This will
warn you the contents have seen temperatures that may not
be conducive for long-term storage.
Power Failure
If your unit experiences a power failure, the LED will flash
amber until the alarm is reset.
Reset Alarms
Press the "ON/OFF" button for approximately one (1) sec-
ond. This will reset all audible and display alarms.
Sabbath Mode
Your refrigerator is equipped with a Sabbath Mode feature.
By activating this mode, you will be disabling all displays,
audible alarms and lights.
To activate Sabbath Mode, press and hold the "SET" but-
ton while pressing the "
seven (7) seconds. To deactivate Sabbath Mode, repeat the
process. Sabbath Mode will automatically deactivate after
72 hours.
Advanced Sentry System™ features:
Sentry System™ continually monitors critical refrigeration
system components for proper operation. If component
parameters exceed normal operation specifications, the
display will automatically flash the respective error code as
follows:
E1-Compressor fault
E2-Condenser fan motor fault
E3-Evaporator thermistor sensor fault
E4-Display thermistor sensor fault
Please call a qualified service technician if any of these
codes are displayed.
LED
LED
F/C" button four (4) times within
°
4
Hide quick links:
Advertisement
Table of Contents
