Marvel 6SBARE-BB-O Installation, Operation And Maintenance Instructions page 15

H
Front of
overlay
panel
Figure 8
Glass Door Models
Model
14-5/16"
3SBARE
(36.35cm)
23-7/16"
6SBARE
(59.54cm)
29-7/16"
8SBARE
(74.78cm)
Table B
Glass Door Models
Step 5: Clamp panel to door
Set the overlay panel on the door front, align the edges,
and clamp together. Clamp the panel firmly but be care-
ful not to crush the foam in the door or scratch the door.
Step 6: Drill holes in overlay panel
Remove the hinge adapter bushings from the top and
bottom door hinge adapters. (See Figure 11).Using the
holes in the hinge adapters drill 5/16" (8mm) diameter
clearance holes into the overlay panels 3/4" (20mm)
deep. These will be clearance holes for the top and bot-
tom hinge pins.
Also at this time drill the screw pilot holes for attach-
ing the overlay panel to the door. Select the size of the
hole from Table C. Be careful not to drill the pilot holes
through the overlay panel but only 1/2" (12.7)mm deep.
FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
W
1-23/32"
(38.77cm)
W H
30-5/16"
(76.99cm)
30-5/16"
(76.99cm)
30-5/16"
(76.99cm)
Material Type
Hardwood
Softwood
Typical 4
If your refrigerator has a door lock proceed to Step 7.
Sides
If your refrigerator does not have a door lock proceed
to Step 9.
Step 7: Mark and drill lock hole.
Locate and mark with a pencil the location of the lock
hole on the overlay panel, this is the hole in the top cor-
ner of the handle side of the door. Remove the clamp and
remove the overlay panel from the door. On the backside
of the panel where you marked the lock location drill a
13/16" (20.5mm) diameter counterbore 7/16" (11.0mm)
deep into the overlay panel. Drill a 15/32" (12.0mm)
diameter hole through the overlay panel centered on the
counterbore being careful not to splinter the wood on the
face side of the panel. (See Figure 9).
Step 8: Assemble the lock parts
Two (2) lock extensions are supplied with the lock. Use
the longer extension for a 3/4" thick overlay panel and
the shorter one for a 5/8" thick panel. Assemble the lock
extension, cam stop washer, spring washer, and set screw
to the lock as shown in Figure 9 and 10.
Install this assembly into the overlay panel and secure
with the retaining nut using a 15mm socket. Make sure
the key slot in the lock is vertical.
SPRING WASHER
LOCK
15/32 HOLE
13/16 COUNTER
BORE 7/16 DEEP
3/4 INCH
WOOD PANEL
#8 Wood Screw
3/32" (2.4mm) Diameter. Pilot Hole
5/64 (2.0mm) Diameter. Pilot Hole
Table C
NOTE
NOTE
BRASS EXTENSION
NUT
SECTION A-A
SCALE 1 : 1
Figure 9
CAM
PHILLIPS SCREW
INNER
DOOR
14