Table of Contents
Advertisement
2. Configure the interval of the alarm sequence.
When more than one alarm of the same priority occurs at the same time, the speed dome will
respond to one alarm first and then respond to the next one after the user-defined interval. You
can set the on SEQUENCE submenu from 1 to 200 seconds.
3. Configure the alarm rest delay.
If there's a linkage action has already been triggered by an alarm input, the speed dome will
only respond to the input from the same channel again after the user-defined reset delay time.
This is the rest time that the speed dome considers an alarm to be active when it's physically
cleared. You can set the DELAY TIME from 0 to 300 seconds.
4. Resume the dome activity.
You can set ALARM RESUME as ON to enable the speed dome to resume its previous activity
after the triggered actions finished.
If the speed dome is moving when a linkage action is triggered, it will stop at the current
position and resume from this position after the linkage action is finished.
The speed dome can be configured to resume the PTZ positions, focus, and iris value.
3.5.3 Configuring Auxiliary Alarm Output
Purpose:
An auxiliary alarm output is a configurable alarm output interface on the speed dome back box
which can connect and trigger another alarm device to operate.
Steps:
1. Enter the alarm output configuration submenu:
MAIN MENUS > DOME SETTINGS > AUXS
2. Click IRIS+ to edit the status of the alarm outputs. You can set the auxiliary alarm output type as
OPEN (normally open) and CLOSE (normally closed).
3. Move the cursor to DWELL TIME to set the duration of the alarm output signal. The configurable
rage is 0 to 60 seconds.
4. Link the alarm output to the configured alarm.
Steps:
HD-TVI Speed Dome User Manual
AUXS
AUX 1
CLOSE
DWELL TIME
AUX 2
OPEN
DWELL TIME
BACK
Figure 3-23 Configure the Alarm Output
2
0
EXIT
34
Advertisement
Table of Contents
