Table of Contents
Advertisement
o Remove the light cover by removing the 4 screws located in the
corners of the glass cover.
o Place the glass cover gently on a supported surface, so that
o Place the lamp cover back into position and fully tighten the 4
screws that were removed previously.
o Replace the side rack, drip trays and oven shelves.
o Restore power to the appliance.
Removing the oven door for cleaning
damage is not caused to it whilst the bulb is
being replaced.
o Unscrew the bulb and remove it from its holder.
o Replace the bulb with a 25 W/300°C, E14 screw
type pygmy.
o Do not use any other type of bulb.
o Fully open the oven door.
o Locate the oven door hinges (see
drawing opposite).
o Tip back the brackets (A) on both
of the hinges.
o You should grip the sides of the door at
the centre and then incline it slightly
towards the oven cavity. By pulling the
lower part of the oven door away from
the oven, the hinges will disengage from
the holes that they are located in.
38
Advertisement
Table of Contents
