Dahua Technology DH-PFR4K-B240 User Manual page 45

Confirm the radar has connected to network correctly before setting network parameters.

Allocate IP address of the same network segment if there is no router in the network.

Set corresponding gateway and subnet mask if there is a router in the network.

Select Setting > Network > TCP/IP.
Step 1
The TCP/IP interface is displayed. See Figure 4-23.
Step 2 Configure parameters. See Table 4-8.
Parameter Description
Host Name Enter host name, 15 characters at most.
Select the Ethernet card that needs to be configured. The default one is Wire.
Ethernet Card
You can change the default Ethernet card if there is more than one card.
Restart radar to activate the new settings once you modify the default settings.

Mode

MAC Address Display the MAC address of radar.
IP Version Select IP version from IPV4 and IPV6 and both versions can be accessed.
IP Address Enter the IP address, subnet mask, and default gateway as needed when
Figure 4-23
Table 4-8 TCP/IP parameter descriptions
DHCP: The system acquires IP address automatically. You cannot set the IP
address, subnet mask and default gateway.
Static: You need to configure IP address, subnet mask and default
gateway manually.
39
TCP/IP
User's Manual