Dahua Technology DH-PFR4K-B240 User Manual page 37

Radar calibration is only for Radar-PTZ Linkage, and you can skip this setting as needed.
Select a PTZ camera in PTZ Camera List, and then enter the username and password used
Step 1
to log in to the web interface of the camera.
You must log in to the PTZ camera before calibration. For details, see "4.1.2 PTZ

Camera".
If you need to link multiple cameras, click PTZ Camera List at the upper-left corner

above the live image to switch to another camera, and then repeat the following
steps.
Step 2 Enter the installation height of the camera.
Enter the height of the lens; otherwise the camera-radar linkage effect will be reduced.
Select Close to turn off Alarm Track; otherwise you cannot calibrate the camera.
Step 3
Select installation methods from Separate and Integrated.
Step 4
Step 5 Add radar coordinates to calibrate radar.
Set coordinates 10 m–20 m away from the PTZ camera and make sure they are

within the radar detection range.
Two people are required: Person A is on the site, and Person B doing configurations

on the Web. Keep A and B stay in contact.
1) Double-click the map to enter full screen, and then click
coordinates.
2) A walks until a green track appears.
After A stops, the track of A will disappear and turn into an orange static track point.
Figure 4-15 Log in to the camera
31
User's Manual
to add radar